Aeroneb Go Manuel d'instructions télécharger pdf (Page 2)

Aerogen and Aeroneb are registered trademarks of Aerogen, Ireland Ltd.

evo Medical Solutions

P/N 22262 Rev G Rx Only

Aerogen (Ireland) Limited,

Galway Business Park,

Dangan,

Galway.

www.aerogen.com

NOTE: (1) If you are using batteries and the green light is flashing, your

batteries are low. You may finish your treatment, and then replace the

three “AA” batteries. (2) If the green light only comes on while depress-

ing the button, immediately replace the three “AA” batteries.

5. Place the mouthpiece between your teeth,

with your lips firmly sealed around the

mouthpiece. If you use an aerosol mask,

place the mask over your mouth and nose.

Breathe in and out slowly through your

mouth until aerosol formation stops. Do not

cover ventilation holes.

NOTE: Aerosol mask is not provided.

NOTE: (1) The Battery Powered Controller is designed to shut off after

16 minutes. If medication still remains in the cup, press the “on/off”

button on the Battery Powered Controller to continue your treatment.

(2) Battery life is dependent upon not only the number of treatments

per day, but also the length of each treatment. It is recommended that

you always have a spare set of new batteries available to you.

6. Press the "on/off" button on the Battery

Powered Controller again to turn the

nebulizer off. Disconnect the cable from the

Nebulizer Unit by sliding the cable straight

down the handset, disassemble Nebulizer

Unit and rinse Nebulizer Unit Parts after each

use. Wipe dry the connector end of the

cable after each use. Clean the Nebulizer

Unit and associated parts daily. Do NOT

remove the retaining ring under the

medication cup.

NOTE: Removal and improper reinsertion of the retaining ring from

the underside of the medication cup may cause the unit to leak or

malfunction.

1. Insert the AC Powered Controller cable

connector into the back of the Nebulizer

Unit by sliding the cable straight up the

nebulizer body.

2. Plug the AC Powered Controller into a

standard AC electrical outlet using the

appropriate outlet adapter. The green light

on the AC Powered Controller will light up.

3. Visually verify that aerosol is coming out of

the mouthpiece or mask to indicate that the

device is functioning properly.

4. Place the mouthpiece between your teeth,

with your lips firmlysealed around the

mouthpiece. If you use an aerosol mask,

place the mask over your mouth and nose.

Breathe in and out slowly through your

mouth until aerosol formation stops. Do not

cover the ventilation holes during use.

NOTE: Aerosol mask is not provided.

5. Unplug the AC Powered Controller from the

wall to turn it off. Disconnect the cable from

the Nebulizer Unit by sliding the cable

straight down the handset, disassemble

Nebulizer Unit and rinse Nebulizer unit Parts

after each use. Wipe dry the Connector end

of the cable after each use. Clean the

nebulizer unit and associated parts daily.

Do NOT remove the retaining ring under

the medication cup.

TO OPERATE BATTERY POWERED CONTROLLER

Model #7010

TO OPERATE AC/DC POWERED CONTROLLER

Model #7030

1. Turn the Battery Powered Controller

upside down. Slide the battery cover in

the direction of the arrow to remove the

lid. Put in three (3) "AA” disposable

alkaline or lithium batteries, matching them

to the plus (+) and minus (-) markings

in side the Battery Powered Controller.

Replace the cover on the Battery

Powered Controller and slide the cover until

it locks in place. You can expect at least

three (3) hours of operation from a new

set of disposable batteries, (up to five (5)

hours from high performance batteries).

2. Insert the nebulizer cable connector into

the back of the Nebulizer Unit. Slide the

cable straight up the nebulizer body.

3. Connect the nebulizer cable to the

Aeroneb

®

Go Battery Powered Controller.

4. Turn on the unit by pressing the "on/off"

button on the Battery Powered Controller.

The green light on the Battery Powered

Controller will light up. Visually verify that

aerosol is coming out of the mouthpiece

or mask to indicate that the device is

functioning properly.

Please read all instructions before using. Refer to your Aeroneb

®

Go Nebulizer

Instruction Manual for more complete instructions.

If you have any questions or problems regarding your Aeroneb

®

Go nebulizer,

contact your local home medical equipment dealer or pharmacy.

Aeroneb Go Manuel d'instructions Page 2

Commentaires sur ces manuels